Manual browser: in4_cksum(9)

Section:
Page:
IN_CKSUM(9) Kernel Developer's Manual IN_CKSUM(9)

NAME

in_cksum, in4_cksum, in6_cksumcompute Internet checksum

SYNOPSIS

uint16_t
in_cksum(struct mbuf *m, int len);

uint16_t
in4_cksum(struct mbuf *m, uint8_t nxt, int off, int len);

uint16_t
in6_cksum(struct mbuf *m, uint8_t nxt, int off, int len);

DESCRIPTION

These functions are used to compute the ones-complement checksum required by IP and IPv6. The in4_cksum() function is used to compute the transport-layer checksum required by tcp(4) and udp(4) over a range of bytes starting at off and continuing on for len bytes within the mbuf m.

If the nxt parameter is non-zero, it is assumed to be an IP protocol number. It is also assumed that the data within m starts with an IP header, and the transport-layer header starts at off; a pseudo-header is constructed as specified in RFC768 and RFC793, and the pseudo-header is prepended to the data covered by the checksum.

The in6_cksum() function is similar; if nxt is non-zero, it is assumed that m starts with an IPv6 header, and that the transport-layer header starts after off bytes.

The in_cksum() function is equivalent to in4_cksum(m, 0, 0, len).

These functions are always performance critical and should be reimplemented in assembler or optimized C for each platform; when available, use of repeated full-width add-with-carry followed by reduction of the sum to a 16 bit width usually leads to best results. See RFC's 1071, 1141, 1624, and 1936 for more information about efficient computation of the internet checksum.

RETURN VALUES

All three functions return the computed checksum value.

STANDARDS

These functions implement the Internet transport-layer checksum as specified in RFC768, RFC793, and RFC2460.

BUGS

The in6_cksum() function currently requires special handling of link-local addresses in the pseudo-header due to the use of embedded scope-id's within link-local addresses.
May 22, 2001 NetBSD 7.0