Manual browser: icp(4)
|ICP(4)||Kernel Interfaces Manual||ICP(4)|
NAMEicp — ICP-Vortex and Intel Storage RAID driver
SYNOPSISicp* at pci? dev ? function ?
ld* at icp? unit ?
icpsp* at icp? unit ?
scsibus* at icpsp?
DESCRIPTIONThe icp driver provides support for the newer (post 1997) ICP-Vortex GDT and Intel Storage RAID controllers.
The ld driver provides access to logical devices (disk arrays) presented by the controller. The icpsp driver provides direct access to other SCSI devices attached to the controller, such as tape or CD-ROM drives.
- pci_mem_find: expected mem type 00000000, found 00000002
- This message may be displayed during autoconfiguration if the controller's memory is mapped below 1MB in physical address space. This can be disabled either through changing a setting in the controller's BIOS utility, or changing the position of a jumper on the board. See your controller's documentation for more information.
HISTORYThe icp driver first appeared in NetBSD 1.6, and was based on the FreeBSD and OpenBSD drivers of the same name.
BUGSISA & EISA front-ends and a management interface are needed.
Older PCI boards are not yet supported.
|April 20, 2002||NetBSD 7.0|