Manual browser: slip(4)
|SL(4)||Kernel Interfaces Manual||SL(4)|
NAMEsl — Serial Line IP (SLIP) network interface
DESCRIPTIONThe sl interface allows asynchronous serial lines to be used as IPv4 network interfaces using the SLIP protocol.
To use the sl interface, the administrator must first create the interface and assign a tty line to it. The sl interface is created using the ifconfig(8) create subcommand, and slattach(8) is used to assign a tty line to the interface. Once the interface is attached, network source and destination addresses and other parameters are configured via ifconfig(8).
The sl interface can use Van Jacobson TCP header compression and ICMP filtering. The following flags to ifconfig(8) control these properties of a SLIP link:
- Turn on Van Jacobson header compression.
- Turn off header compression. (default)
- Don't pass through ICMP packets.
- Do pass through ICMP packets. (default)
- If a packet with a compressed header is received, automatically enable compression of outgoing packets. (default)
- Don't auto-enable compression.
- sl%d: af%d not supported.
- The interface was handed a message with addresses formatted in an unsuitable address family; the packet was dropped.
SEE ALSOinet(4), intro(4), ppp(4), strip(4), ifconfig(8), slattach(8), sliplogin(8), slstats(8)
J. Romkey, A Nonstandard for Transmission of IP Datagrams over Serial Lines: SLIP, RFC, 1055, June 1988.
Van Jacobson, Compressing TCP/IP Headers for Low-Speed Serial Links, RFC, 1144, February 1990.
HISTORYThe sl device appeared in NetBSD 1.0.
BUGSSLIP can only transmit IPv4 packets between preconfigured hosts on an asynchronous serial link. It has no provision for address negotiation, carriage of additional protocols (e.g. XNS, AppleTalk, DECNET), and is not designed for synchronous serial links. This is why SLIP has been superseded by the Point-to-Point Protocol (PPP), which does all of those things, and much more.
|July 9, 2006||NetBSD 7.0|